Reconnect the trailer cord to the tow vehicle. When testing is completed, re-insert the pin so it is flush with the switch body and the trailer brakes release. Double check by moving the tow vehicle forward, making sure the brakes are locked and operating properly.Ĩ. When testing the switch, disconnect trailer cord from the tow vehicle. Make sure the lanyard cable is not damaged and the battery is fully charged and maintained.ħ. Curt Manufacturing 52010 Nylon Breakaway Switch With Switch Pin Lanyard. Curt Manufacturing 52022 Lockable Battery Box. Test the breakaway switch on a regular basis. This item: Curt Breakaway Battery, Black. Fasten the cable to the tow vehicle frame – Not on the safety chains or the tow ball.Ħ. Do not let lanyard cable drag on the ground. Push the pin back into the switch until the flange on the pin isįlush with the switch body. After the switch has been installed and wired in, pull the lanyard pin out of switch to make sure the brakes engage. Wire the breakaway switch as in wiring diagram.Ĥ. pull on the switch and will allow the switch to swivel.ģ. Tekonsha Shur-Set III Breakaway Kit, includes a 5Amp battery with lockable case & nylon breakaway switch. The breakaway should be bolted to the trailer frame with minimum 1/4” bolt that will accept a 75 lb. Tow Secure TS2000 Breakaway Control + Harness with TEKONSHA SWITCH. Make sure the tow vehicle can make sharp right and left turns without straining the lanyard cable.Ģ. There should be no strain or obstacles interfering with the lanyard cable connected to the tow vehicle. Mount the breakaway switch on a horizontal plane as close to the hitch as possible. Switch is installed according to the following procedure. Will close the circuit from the trailer battery to the brakes and put the brakes on.įor the breakaway switch to operate properly it is important that the trailer battery is sized to the brakes of the trailer, the terminals connections clean, the battery fully charged, and the When this happens the lanyard cable pin is pulled out of the breakaway switch and the switch The break away switch should be wired so that it is a normally open circuit that closes when the pin is pulled. The reason that pulling your break away switch does not actuate your brakes is that it is not wired correctly. A typical position is on the inside of one of the trailer frames in the front of the trailer. The break away system on a trailer would typically have its own battery, like that shown with part 20400. The switch is designed to operate only when the towed trailer separates from the towing vehicle. Breakaway battery box - houses a 12 volt battery and, in some models, a battery charger Mounting the Breakaway Kit Locate a secure surface on the trailer to mount the breakaway kit battery box.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |